The following examples demonstrate how our customers successfully exploit MAGMASOFT® in order to realize better casting quality, cost savings or reduction of development times.

Riser Redesign to Feed Wheel Hub

Metalurgica Frum was trying to develop a wheel hub for several months without success. ... read more

Cold Laps in Cast Iron

DANA Spicer has used MAGMASOFT® to develop unconventional gating systems for ductile iron ... read more

Fly Wheel Casting Simulation

Large cast iron castings require a high degree of attention in designing the layout, due to the ... read more

New Markets for Casting

During recent years, the market for wind power has grown by orders of magnitude and has created ... read more

Solving a Weighty Cracking Problem

Wheel weights are used on farm machinery to improve traction, as well as to balance tractors ... read more

Optimal Casting – Local Specification

The gating and riser layout for this ductile iron casting was optimized with MAGMASOFT®. ... read more

Stresses That Could Bring You to Boiling

A boiler manufacturer approached MAGMA with a problem where a casting had failed in use. ... read more

Working Under Pressure

Blind risers can only work properly for the limited number of cast alloys with a strong ... read more

(Residual) Stress Shortens Lifetime

Especially in the recent past, numerous diesel cylinder heads have been developed that showed ... read more

Trying to Get By Without a Riser

Stator housings are produced at the ITT foundry in Emmaboda, Sweden. ... read more

This site uses cookies to offer you a better browsing experience Privacy policy