Core Cost Savings

When trying to produce cores with challenging geometries there can be many challenges both in the shooting phase and the curing phase.  The following webinar looks at how simulation was used to predict core defects for the shooting phase as well as the curing phase for a turbocharger volute core.  

 

Autonomous Engineering® was used to test 1000+ different venting configurations which yielded a number of acceptable designs.  A cost analysis was then performed on these acceptable designs where purging times became the main focus since a reduction in purging time can translate into a reduction in labor costs and thus the manufacturing costs for the volute core. 

Click this link to watch on OnDemand: Core Cost Savings

and process parameters were effecting the curing gas flow during the curing process
This site uses cookies to offer you a better browsing experience

Privacy policy    -    Legal Notice


Deny Accept